Printing
Within the printing industry, the need for precise surface performance is critical to ensure high quality prints. Both consumer and commercial printing system components may experience unique chemical environments, excess wear on printer rollers, and a requirement to provide dielectric surface properties which are only possible through our advanced thermal spray coatings. WESCOAT® coatings provide a cost-effective solution to ensure critical components operate at a high level of efficiency. Our wide range of specialty and customizable coating solutions are geared toward highlighting the longevity, safety and performance of your printing components.
Our expertise with a wide variety of material used by the printing industry enables us to develop unique solutions for each customer’s needs. WESCORP offers a variety of single source thermal spray solutions for various printing components including but not limited to:
- Printer Rollers (Anilox & Impression Rollers)
- Cylinders & Printing Plates
- Wear Strips & Guides
- Roller Bearings & Shafts
- Ink Pumps & Transfer Components
- Gripper Bars & Fingers
- Doctor Blades
- Drums
WESCOAT® Featured Printing Products
WESCOAT® CX01P6
- Tensile Strength (PSI) 6000
- Hardness: (HV or HRC) 74 HRC
- Porosity: 2%
- Max Service Temp: 1000°F Wear, 400°F Corrosion
- This product will solve for wear and erosion as well as chemical concerns.
WESCOAT® WC01P6
- Tensile Strength (PSI) 7500
- Hardness: (HV or HRC) 60 HRC
- Porosity: <2%
- Max Service Temp: 930°F
- This product will solve for wear and erosion concerns.
WESCOAT® AX01P6
- Tensile Strength (PSI) 7500
- Hardness: (HV or HRC) 65 HRC
- Porosity: <1%
- Max Service Temp: 3000°F Wear
- This product will solve for electrical, thermal as well as wear and erosion concerns.
WESCOAT® AX02P6
- Hardness: (HV or HRC) 86-94 HRC
- Max Service Temp: 2010°F Wear
- This product will solve for electrical, thermal as well as wear and erosion concerns.
WESCOAT® MA05H2
- Tensile Strength (PSI) 3000
- Hardness: (HV or HRC) 40 HRC
- Max Service Temp: <1200°F
- This product will solve for wear and erosion as well as chemical concerns.